Window and Door Installation in Houston

Replacement Windows

We replace single windows or the whole house, sizing each opening correctly and planning the interior trim so the new windows look built-in rather than set-in. Frame condition is inspected during removal, and any rot or damage found is repaired before the new unit goes in.

Glass options are chosen for the Houston climate — low-emissivity coatings, insulated glazing, and tinting or coatings where western exposure makes rooms uncomfortable. Actual energy outcomes depend on the home, and we discuss realistic expectations rather than promising savings figures.

Exterior, Entry, and Patio Doors

An entry door is the handshake of the house. We install exterior doors that seal against Houston’s wind-driven rain, with correct flashing, sweeps, and threshold detailing — and hardware, glass, and finish chosen to match the home’s architecture.

Patio and sliding doors get particular attention to the opening: track level, drainage, and interior floor transitions, so the door glides and drains the way it was designed to.

Interior Doors

Replacing interior doors is one of the highest-impact refreshes available: consistent heights, aligned casings, and matching hardware change how an entire house reads. We hang doors that swing true, latch cleanly, and line up across hallways.

Houston Heat, Humidity, and Storms

Houston windows and doors face three enemies: sustained heat and UV, moisture-laden air, and storm-driven rain. Products and installation details are chosen for all three — sealants rated for high temperatures, flashing layered to shed water, and finishes that hold up to Gulf Coast sun.

We do not represent any window or door product as hurricane-proof, and we do not promise energy-bill savings. What we do is install weather-appropriate products to manufacturer specifications with water management detailed correctly.

Flashing and Water Management

Most window and door failures are water failures, and they happen behind the finish. Installation follows a layered flashing approach — sill protection first, then the unit, then sealed weather barriers — so that water that gets past the face of the wall still drains out.

Rough openings are inspected and corrected before installation. A window installed in a compromised opening will leak no matter how well it is made.

Trim Repair and Finishing

Removing an old window or door often reveals trim, siding, or sheathing that needs repair. That work belongs in the same scope — exterior trim rebuilt and caulked, interior casing matched to the home’s trim profiles, and paint finished to blend with existing walls.

The goal is an installation where nothing looks new but the product itself.

Signs Replacement May Be Needed

Some failures are obvious: fog between glass panes, rot at the sill, locks that no longer engage, or a door that will not close in summer humidity. Others are quieter — paint peeling around a frame, floors darkening below a window, or rooms that never feel comfortable.

• Condensation or fog permanently trapped between panes
• Difficulty opening, closing, or locking windows and doors
• Soft or discolored wood at sills and frames
• Drafts and outside noise noticeably worse than in other rooms
• Water staining on walls or floors near an opening